View Faulted Or Bypassed Points - Bosch D1260 Owner's Manual

Part I: Security System Basics

View Faulted or Bypassed Points

View Faulted or Bypassed Points
To properly arm your system, all the doors and windows in the system must be in the normal (not faulted) condition.
Viewing the faulted points helps you find faulted points and correct them so proper arming is possible.
Your command center offers two ways of displaying faulted and bypassed point information. The first causes the faulted
or bypassed point information to scroll automatically through the display. The second allows you to manually scroll
through each individual point description.
To automatically scroll faulted or bypassed points:
1. Ensure your command center shows idle text.
The View Points> soft key may be displayed on the third line of the
command center if there are faulted points.
2. Press any number key. The text for Area 1 is displayed first followed
by the number (#) of faulted points on the next line.
3. The display changes to show the point text description of the
faulted points. If there is more than one faulted point, the display
will automatically cycle through all of them before returning to idle
text.
These displays scroll at the rate of 3 seconds each.
4. The display returns to idle text after scrolling through the faulted
and bypassed point information.
The View Points> soft key will be shown when there are faulted
points.
50410C
D1260 Owner's Manual
© 2003 Bosch Security Systems