Burglary Alarms - Bosch D1260 Owner's Manual

Burglary Alarms

Burglary alarms are the second priority. When a burglary point activates while your system is armed, your command
center emits a steady high-pitched burglary tone. The tone sounds for the time set by your security company.
The command center display shows the number of burglary
points activated, the point text then idle text
If there is more than one point causing an alarm,
the display will show each point for three seconds
before showing the next one. When the last alarm
is shown, the next display is idle text followed by
the first alarm.
Silencing Burglary Alarms
Entering a personal passcode with the proper authority level silences a burglary alarm and disarms the system if it was
armed.
The system will now display *Alarm Silenced*
and then the number of points in alarm ### Alarms and the
custom text of all the points in alarm, in the order of occurrence.
Entering COMMAND 4 clears the scrolling point text from the display.
The *Alarm Silenced* message will continue to alternate with
idle text as a reminder that it is still possible to view the text of
the points in alarm by using the View Memory function. See
VIEW MEMORY ? (Command 40) for more information.
To clear the event memory and remove the *Alarm Silenced*
message from the display, press the Clear Display> soft key.
© 2003 Bosch Security Systems
Part I: Security System Basics
3 seconds
3 seconds
3 seconds
D1260 Owner's Manual
Burglary Alarms
3 seconds
50410C