Unbypass A Point? (Command + 0 + 0) - Bosch D1260 Owner's Manual

UNBYPASS A POINT? (COMMAND + 0 + 0)

Description
Unbypassing a point is a way to return a bypassed point to the security system so that it can once again respond to
trouble and alarm conditions.
Using Unbypass a Point:
1. Ensure your command center shows idle disarmed
text.
2. Press the COMMAND key.
3. The display shows *System Command*.
4.
Press the 0 key twice.
Note: If you prefer, you may use the Command Menu in place of steps 2 and 3 to initiate this function.
Press the Menu> soft key to enter the Command Menu,
then press Next> soft key repeatedly
until you reach the UNBYPAS A POINT ?> prompt then press
the adjacent soft key.
5. You will prompted for your passcode. It will appear on
the display as asterisks (*).
6. The display changes to show Enter point number or
press next key.
7. If digits are pressed, the display shows Enter point
number: #. As soon as a digit key is pressed, the display
changes to Entering point number:.
(# is the point number that was entered)
If you know the point number you wish to unbypass,
enter the number and press the Enter> soft key
or the ENTER button.
© 2003 Bosch Security Systems
Part III: Advanced Commands
UNBYPASS A POINT? (COMMAND + 0 + 0)
D1260 Owner's Manual
+
50410C