Bosch D1260 Owner's Manual page 86

Part III: Advanced Commands
CHG PASSCODES ? (COMMAND + 5 + 5)
7. Press the ENTER button.
If an invalid passcode is entered, the command center
will momentarily display Passcode is already in use.
Please try again.
8. If the new passcode is valid, the display changes to
Enter new passcode again:
Enter the new passcode again.
As soon as a number is pressed, Entering: appears on
the third line next to the asterisks.
The passcode is shown as asterisks (*) when entered and advance from the right side of the display
to the left until all six passcode digits are entered.
9. If the passcode matches the previously entered
passcode, the display changes to Passcode changed.
If the passcode does not match, the command center
will emit a error tone and display Passcode not
changed.
10. The display automatically returns to idle text after
three seconds.
50410C
D1260 Owner's Manual
© 2003 Bosch Security Systems