Bosch D1260 Owner's Manual page 64

Part III: Advanced Commands
REMOTE PROGRAM ? (COMMAND + 4 + 3)
7. Press the Answer Now> soft key to connect to RAM.
Note: When your security company is communicating with your panel during a RAM session, the D1260 may display
Call for Service...
8. The display shows RAM connecting...
9. The security system will now disconnect telephones sharing its telephone line during the remote
programming session. Hang up the telephone now.
10. At the conclusion of the programming session your
system sends a report to the security company and
then returns your telephone to normal service and
your display to idle text.
For systems with a phone number or network connection
1. Ensure your command center shows idle disarmed
text.
2. Press the COMMAND key.
The display shows *System Command*.
3. Press the 4 key then the 3 key.
Note: If you prefer, you may use the Command Menu in place of steps 2 and 3 to initiate this function.
Press the Menu> soft key to enter the Command Menu,
then press Next> soft key repeatedly
until you reach the REMOTE PROGRAM ?> prompt and press
the adjacent soft key.
4. The display changes to show the two choices that are
available for connecting to RAM:
•
Answer Now
•
Contact RAM: RAM via phone or network
5. Press the Contact RAM> soft key to specify the
connection method to RAM.
50410C
My system uses a phone number for Remote Programming
My system uses an IP Address and network connection for Remote Programming
D1260 Owner's Manual
© 2003 Bosch Security Systems