Fire Trouble And Fire Supervisory Events; Non-Fire Trouble And Supervisory Events; Special System Trouble Display - Bosch D1260 Owner's Manual

Fire Trouble and Fire Supervisory Events

When a fire trouble or fire supervisory condition occurs, your command center emits three warble tones, then a pause
(repeatedly).
The system displays the number of fire points that are in a
trouble or supervisory condition as well as the point text of the
affected points.
Silencing Fire Trouble and Fire Supervisory conditions
Pressing COMMAND 4 or the Silence> soft key silences the conditions. In addition to this, entering a personal passcode
with the proper authority level silences the condition and disarms the panel if it was armed. If you wish to review these
cleared troubles, using COMMAND 40 can do this.
Note: Some systems may be programmed to automatically re-sound the command center's trouble tone after a period of
time if the fire trouble or fire supervisory condition remains. Consult your security company for further
information.
Special Fire Trouble and Fire Supervisory Display
If you silence the command center or clear a trouble or supervisory condition for a Fire Point from the display and the
fire point remains in trouble, Fire Trouble or Fire Supervisory appears in the command center's display. This remains in
the display until the condition causing the trouble is cleared.
Note: Some fire points, when tripped, will display FIRE TROUBLE for a preset amount of time. If no other fire activity
is detected, this condition will automatically clear. If the condition remains or another fire detector is tripped, a
fire alarm will occur.
Viewing Fire Trouble and Fire Supervisory conditions
After pressing COMMAND 4 or entering your passcode, the text of the fire point in trouble continues to automatically
scroll through the display. Press View Points> soft key and then Next> soft key to scroll these displays manually if you
wish. Events scroll in chronological order.

Non-Fire Trouble and Supervisory Events

When a trouble event occurs, your command center may be programmed to emit three warble tones, then a pause
(repeatedly).
If the system was armed the command center display shows the number of non-fire trouble events or non-fire
supervisory events and then custom text for each activated point.
Silencing Non-Fire Trouble and Supervisory Events
Pressing COMMAND 4 or the Silence> soft key silences the Trouble and/or non-fire Supervisory conditions. In addition
to this, entering a personal passcode with the proper authority level silences a trouble and disarms the panel if it was
armed. Press the View Points> soft key then the Next> soft key to scroll these displays manually. If you wish to review
these cleared troubles, use COMMAND 40 to do this.

Special System Trouble Display

These displays appear on all keypads in the system. See Standard Displays for a description of each system trouble
display. Entering your passcode, COMMAND 4 or pressing the Silence> soft key will silence a system trouble tone, but
the System Trouble display will not clear until the faulted condition is corrected.
A system trouble display begins by sounding a trouble tone and then
three seconds later the specific System Trouble Display is shown,
such as Service AC Fail.
Note: Some system may be programmed to not initiate a trouble
tone during these conditions.
Cleared Events Are Not Lost
If you clear the alarms and troubles from the display, you can still view all the events that occurred since the last time the
system was armed by using COMMAND 40 (View Event Memory).
© 2003 Bosch Security Systems
Part I: Security System Basics
Fire Trouble and Fire Supervisory Events
D1260 Owner's Manual
50410C