Program Phone Numbers - Bosch Solution 2000 Programming

To delete an RF device:
1. Enter the RF device
2. Enter the zone number (1 - 16) of the RF device you want to delete, e.g.:
3. Press the [ * ] button to delete it.
XIV. Program Phone Numbers
If the alarm system is connected to the phone line or a 2G/3G GSM device, then you can
program two phone numbers into the system that will be called in the event of an alarm.
First, you need to set the system up for domestic dialling:
1. Enter programming mode:
2. Activate domestic dialling:
3. Save and exit:
Next, you need to program the first (primary) number you want the system to call in
the even of an alarm:
1. Enter the domestic phone master code operation:
2. Select phone number 1 to enter:
3. Enter the phone number, e.g.:
If you would like to enter a second phone number:
1. Enter the domestic phone
2. Select phone number 2 to enter:
3. Enter the phone number, e.g.:
In the event of an alarm, the system calls the primary number first, making several
attempts of each number until it is successful. To acknowledge the alarm event, you
need to answer the call, then press the [ * ] button during the pause of the siren
tone that is transmitted by the alarm system.
If you wish to disable domestic dialling and cancel the phone numbers from the system,
enter the following
confirm and exit.
XV. Set Date & Time
The date and time can also be set using the master code operation: [ MC 6 # ]. The date
uses the following format: DD/MM/YY, whilst time is in 24-hour time in the following
installer code
[ 1 2 3 4
[ 9 6 5 # ]
[ 9 6 0 # ]
[ 1 # ]
[ 0 4 1 1 9 6 0 8 8 7 # ]
master code
[ 2 # ]
[ 0 4 0 1 8 9 9 6 7 0 # ]
master code sequence:
operation: [ 1 2 3 4
# ]
[ 2 5 8 0
operation: [ 2 5 8 0
[ 2 5 8 0 2 # 1 * 5 #
0 # ]
2 # ]
2 # ]
], then press
[ 9 # ]
[ # ] again to
Page !11 of !12