Chg Relays ? (Command + 5 + 4) - Bosch D1260 Owner's Manual

CHG RELAYS ? (COMMAND + 5 + 4)

Your security company may program relays for automatic control and/or control from your command center of devices
such as premises lighting or entry gates. Contact them for further information regarding the use of relays in your security
system.
1. Ensure your command center shows idle disarmed
text.
2. Press the COMMAND key.
3. The display shows *System Command*.
4. Press the 5 key and then the 4 key.
Note: If you prefer, you may use the Command Menu in place of steps 2 and 3 to initiate this function.
Press the Menu> soft key to enter the Command Menu,
then press Next> soft repeatedly
until you reach the CHG RELAYS ?> prompt then press the
adjacent soft key.
5. The command center display changes *Change Relay*
Enter relay number:
Valid entries are 1 to 128, depending how the system is
configured.
Enter the relay number then press either the Enter>
soft key or the ENTER button.
6. If the relay is valid and turned off, the display changes
to Change Relay* Relay 123 is currently off.
(123 is used as an example.)
Press the Turn on> soft key to turn on the relay.
7. If the relay is valid and turned on, the display changes
to Change Relay* Relay 123 is currently on.
(123 is used as an example.)
Press the Turn off> soft key to turn off the relay.
© 2003 Bosch Security Systems
Part III: Advanced Commands
CHG RELAYS ? (COMMAND + 5 + 4)
D1260 Owner's Manual
50410C