View Faulted Or Bypassed Points - Bosch Security System User Manual

View Faulted or Bypassed Points

To properly arm your system, all the exterior points
(doors and windows) and interior points (motion
sensors, inside doors, etc.) in the system must be in the
normal (not faulted) condition. Viewing the faulted
points helps you find faulted points (such as doors or
windows that are left open) and correct them so proper
arming is possible.
Your command center offers two ways of displaying
faulted and bypassed point information. The first causes
the faulted or bypassed point information to scroll
automatically through the display. The second allows
you to manually scroll through each individual point
description.
To automatically scroll faulted or bypassed
points:
1. Ensure your command center shows idle text.
The View Points> soft key will be displayed on
the third line of the command center when
there are faulted points.
4998122475C
View Faulted or Bypassed Points
2. Press the digit key. The text for Area 1 is
displayed first followed by the number (#) of
faulted points on the next line.
Press the View Points> soft key to
automatically scroll through the faulted points
3. The display changes to show the point text
description of the faulted points. If there is
more than one faulted point, the display will
automatically cycle through all of them before
returning to idle text.
These displays scroll at the rate of 3 seconds
per faulted point.
4. If there are no faulted or bypassed points, the
View Points> soft key will not appear. Instead,
the display shows Area Is Off idle text.
5. The display returns to idle text after scrolling
through the faulted and bypassed point
information.
Security System User's Guide
Part I: Security System Basics