Configuring Event Management - Destinations - Raritan Dominion KX II-101-V2 User Manual

Note: IPv6 addresses cannot exceed 80 characters in length for the host
name.
Use the reset to factory defaults feature to remove the syslog
configuration and set the KX II-101-V2 to its original factory default.
To reset to factory defaults:
1. Click Reset To Defaults.

Configuring Event Management - Destinations

System events, if enabled, generate SNMP notification events (traps), or
can be logged to the syslog or audit log. Use the Event Management -
Destinations page to select the system events to track and where to
send this information.
Note: SNMP traps are generated only if the SNMP Logging Enabled
option is selected. Syslog events are generated only if the Enable Syslog
Forwarding option is selected. Both of these options are in the Event
Management - Settings page. See
Settings (on page 118).
To select events and their destinations:
1. Choose Device Settings > Event Management - Destinations. The
Event Management - Destinations page opens.
System events are categorized by Device Operation, Device
Management, Security, User Activity, and User Group Administration.
2. Select the checkboxes for those event line items you want to enable
or disable, and where you want to send the information.
Tip: Enable or disable entire Categories by checking or clearing the
Category checkboxes, respectively.
3. Click OK.
To reset to factory defaults:

Click Reset To Defaults.
WARNING: When using SNMP traps over UDP, it is possible for the
KX II-101-V2 and the router that it is attached to fall out of
synchronization when the KX II-101-V2 is rebooted, preventing the
reboot completed SNMP trap from being logged.
Chapter 6: Device Management
Configuring Event Management -
125