802.1w Rapid Spanning Tree Protocol (RSTP) and 802.1d Spanning Tree Protocol (STP)
CLI: Configuring 802.1D STP
STP Commands Used in This Section
show spanning-tree config
spanning-tree
protocol-version
forward-delay <4 - 30>
hello-time <1 - 10>
maximum-age <6 - 40>
priority <0 - 65535>
ethernet <port-list>
path-cost <1 - 65535>
priority <0 - 255>
mode <norm | fast>
show spanning tree
Viewing the Current STP Configuration. Regardless of whether STP is
disabled (the default), this command lists the switch's full STP configuration,
including general settings and port settings.
Syntax:
show spanning-tree config
When the switch is configured for 802.1D STP, this command displays infor
mation similar to the following:
Figure 14-9. Example of the Default STP Configuration Listing with 802.1D STP
Configured at the Protocol Version
802.1D Spanning-Tree Protocol (STP)
Below
page 14-22
page 14-23
page 14-23
page 14-23
page 14-23
page 14-24
page 14-24
page 14-24
page 14-24
Lists additional STP data not covered in this chapter. See
"Spanning Tree Protocol (STP) Information" on page B-17
Command Listing when
STP is the Protocol Version
(See also page 14-10
14-21