Cli: Configuring Stp - HP 4108GL Management And Configuration Manual

7. When you are finished editing parameters, press [Enter] to return to the
Actions line.
8. Press [S] to save the currently displayed STP parameter settings, then
return to the Main Menu.

CLI: Configuring STP

STP Commands Used in This Section
show spanning-tree config
spanning-tree
forward-delay <4 - 30>
hello-time <1 - 10>
maximum-age <6 - 40>
priority <0 - 65535>
ethernet <port-list>
path-cost <1 - 65535>
priority <0 - 255>
mode <norm | fast>
show spanning tree
Viewing the Current STP Configuration. Regardless of whether STP is
disabled (the default), this command lists the switch's full STP configuration,
including general settings and port settings.
show spanning-tree configuration
Syntax:
In the default configuration, STP appears similar to the following:
Below
page 16-6
page 16-7
page 16-7
page 16-7
page 16-7
page 16-8
page 16-8
page 16-8
page 16-8
This command lists additional STP monitoring data not
covered in this chapter. See "Spanning Tree Protocol (STP)
Information" on page 17-17
Spanning Tree Protocol (STP)
CLI: Configuring STP
16-5