Troubleshooting: How Ito Reports Errors; Errors Reported In Logfiles - HP -UX B6941-90001 Administrator's Reference Manual

Tuning, Troubleshooting, Security, and Maintenance

Troubleshooting: How ITO Reports Errors

Troubleshooting: How ITO Reports
Errors
This section describes how ITO processes and reports errors during
operation. The section is broken down into three areas:
Errors reported via logfiles.
Errors reported via the Message Browser.
The Error Dialog Box in the GUI.
stdout and stderr in the shell.
Errors Reported in Logfiles
Error messages are written to two different locations:
1. All errors detected by the ITO server or by agent processes are
written to the appropriate log file.
2. In addition (if possible) an ITO message is generated for display in
the Message Browser.
In event of a problem, you should always check the ITO error log files.
The following list indicates where you may find information relating to
the operations described:
Errors reported by ITO manager processes on the management
server during operation, are written to
/var/opt/OV/log/OpC/mgmt_sv/opcerror
Errors reported during the installation of software on the managed
nodes, are written to the following file on the management server.
/var/opt/OV/log/OpC/mgmt_sv/inst_err.log
Errors reported by agent processes during the operation of ITO are
written (on the appropriate managed node) to the locations specified
in Table 10-2 on page 387:
386 Chapter 10