HP -UX B6941-90001 Administrator's Reference Manual page 54

Installing ITO Agents on the Managed Nodes
General Installation Tips for Managed Nodes
Install the Agent on the Managed Node:
Use the following instructions to install the ITO AIX agent on an AIX
system that will become an ITO managed node:
1. Copy the ITO agent package to a temporary directory on the managed
node. On the management server, this agent package is located in:
/var/opt/OV/share/databases/OpC/mgd_node/vendor/ibm/\
rs6000/aix/A.05.00/RPC_DCE_[TCP|UDP]/opc_pkg.Z
If you intend to run ITO Advanced Network Security (ANS) on this
node, you also need to copy the file:
/var/opt/OV/share/databases/OpC/mgd_node/vendor/ibm/\
rs6000/aix/A.05.00/RPC_DCE_[TCP|UDP]/nsp_pkg.Z
2. Uncompress the agent package:
uncompress opc_pkg.Z
If appropriate, uncompress the ANS package, too:
uncompress nsp_pkg.Z
3. Install the agent on the node:
installp -ac -I -X -F -d<directory>/opc_pkg all
If appropriate, install ANS on the node, too:
installp -ac -I -X -F -d<directory>/nsp_pkg all
Activate the Node Using the Command Line:
You can activate the agent on the node over the net (without the GUI and
without root access) by using the following command-line steps:
1. After manually installing the agent on the node, enter:
/opt/OV/bin/OpC/install/opcactivate <
-cs <server_codeset> -cn <agent_codeset>
This will activate the agent, which will then attempt to send
messages to the management server. For more information about
codesets, see Chapter 8, "ITO Language Support," on page 333.
54
ITO
_mgt_server>\
Chapter 2