HP -UX B6941-90001 Administrator's Reference Manual page 68

NOTE
TIP
Installing ITO Agents on the Managed Nodes
General Installation Tips for Managed Nodes
c. Install the agent on the node:
swinstall -x source_type=tape -s\
/<full_path>/opc_pkg OVOPC-AGT
If appropriate, install the ANS package on the node, too:
swinstall -x source_type=tape -s\
/<full_path>/nsp_pkg ITOAgentNSP
For cluster nodes, use swcluster, instead of swinstall, on the cluster
server.
d. Examine the node's logfile /var/adm/sw/swagent.log. If
any errors occurred during installation, correct the problems
and reinstall.
• Using an existing SD depot:
a. Install the agent on the node:
swinstall -s <
If appropriate, install the ANS agent package on the node, too:
swinstall -s <
ITOAgentNSP
b. Examine the node's logfile /var/adm/sw/swagent.log. If
any errors occurred during installation, correct the problems
and reinstall.
Installing the agent from the command line is somewhat faster than
with the SD GUI, but it has the disadvantage that it does not notify you
of any warnings found in the analysis phase unless you run it twice and
set the -p option in the first run. If you would like to use the GUI, simply
omit the name of the agent package (OVOPC-AGT) when you enter the
swinstall command.
Installing the agent package will produce dependency errors, because the
package does not hold all the files necessary for the agent to run. If you
want to be certain that all these files exist, you can use the command
/usr/sbin/swlist -l product to get a list of all software that is
installed on the node.
68
depot_host depot_path
:
depot_host depot_path
:
> OVOPC-AGT
>\
Chapter 2