HP -UX B6941-90001 Administrator's Reference Manual page 69

Activate the Node Using the Command Line
You can activate the agent on the node over the net (without the GUI and
without root access) by using the following command-line steps:
1. After manually installing the agent on the node, enter:
opcactivate <ITO_mgt_server> -cs <server.codeset> \
-cn <agent.codeset>
See also Chapter 8, "ITO Language Support," on page 333 for more
information about codesets.
This will activate the agent, which will then attempt to send
messages to the management server.
2. After the node is connected to the network execute the following two
commands on the management server:
a. /opt/OV/bin/OpC/opcsw -installed <node>
b. /opt/OV/bin/OpC/opchbp -start <node>
This will update the database and start heartbeat polling for the
node. The templates, monitors, commands, etc. must still be installed
using the management server GUI.
Activate the Node Using the ITO GUI
After the node with the pre-installed agent is connected to the network,
use this procedure to activate and register the managed node.
1. Add the pre-installed node(s) to the ITO Node Bank using the menu
sequence: Actions-> Node-> Add.
2. Add the node to an ITO node group. The easiest way to do this is to
drag and drop it onto a node group in the ITO Node Group Bank
window.
3. Select: Actions-> Agents-> Install to bring up the Install
/Update ITO Software and Configuration window. Select all
components (but do not check [Force Update] otherwise the
management server will re-install the agent), then click [OK]. If the
agent is pre-installed on the node, the management server will
activate the node, and install the selected components. Note that if
the agent software is not pre-installed, this action will install the
agent.
Chapter 2
Installing ITO Agents on the Managed Nodes
General Installation Tips for Managed Nodes
69