HP -UX B6941-90001 Administrator's Reference Manual page 32

Prerequisites for Installing ITO Agent Software
Managed Node Requirements
Operating System
OS/2 Warp
SCO OpenServer
SCO UnixWare
SINIX/Reliant
Solaris
Windows NT
a. DCE can be purchased at additional cost for some of these agent platforms, either
from the platform vendor, or from a third-party supplier.
b. HP 9000/700 workstations are now referred to as HP 9000 Technical
Workstations.
c. HP 9000/800 servers are now referred to as HP 9000 Enterprise Servers.
d. ITO uses the same binaries as for HP 9000 Technical Workstations.
e. NCR hardware types: 4700, 5100, and 5150 are supported only if the installed ver-
sion of the standard NCR UNIX operating system is supported by ITO and any
additional software which is installed does not change the IP address of the NCR
node under any circumstances (takeover, etc).
f. Transport Independent Remote Procedure Call
g. ITO does not yet support special editions of the Windows NT Server operating
system; for example, Windows NT Server Enterprise Edition or Windows NT
Server Terminal Server Edition; nor does it support any software products
extending these editions; for example, WinFrame or MetaFrame from Citrix
Systems, Inc.. Contact your local HP Sales Representative for the latest
information about support for these products.
h. ITO supports the remote protocol calls (RPCs) but not the security features.
Additional agent platforms may also be supported by HP partners, or
directly by HP, either currently or in the near future. For a current list of
supported agent platforms, contact your HP representative.
32
Platform
Intel 486 or higher
Intel 486 or higher
Intel 486 or higher
Siemens-Nixdorf
Sun SPARCstation
Intel 486 or higher
DEC Alpha
Supported OS
Versions
3.0, 4.0
3.2 (v4.0, v4.2,
v5.0.0, v5.0.1, v5.0.2,
v5.0.3, v5.0.4, v5.0.5)
2.1
5.43, 5.44
2.5, 2.51, 2.6, 7
3.51, 4.0 (NT server
g
and workstation)
Supported
Communication
a
Type
DCE
NCS
DCE
NCS/DCE
NCS
h
DCE
Chapter 1