Setting A Frequency; Preparation - Icom IC-2820H Instruction Manual

2

SETTING A FREQUENCY

■ Preparation

D Turning power ON/OFF
[PWR]
➥ Push and hold [PWR] for 1 sec. to turn power ON and
OFF.
D MAIN band
The IC-2820H can receive 144 MHz and 440(430) MHz band
signals simultaneously. To change or activate any of the func-
tions or to change frequency via the microphone, you must
designate one band as the main band. The transceiver trans-
mits a signal on the main band only.
[MAIN•BAND]
➥ Push the desired band's [MAIN•BAND] to select the main
band.
• "Q" indicates the main band.
➥ Push [BAND] to toggle the main band between
BAND left and right bands.
15
D Operating frequency band selection
In the default condition, or after resetting the CPU, 2 m band
is assigned to the left band, 70 cm band is assigned to the
right band. However, the 2 m band can also be assigned into
the right, and 70 cm band can also be assigned into the left
band.
[MAIN•BAND]
[DIAL]
Frequency band initial is displayed.
q Push and hold the desired band's [MAIN•BAND] for 1 sec.
• Frequency band initial appears.
wRotate the same band's [DIAL] to select the desired fre-
quency band.
• Pushing [Y]/[Z] on the microphone also selects the band.
ePush the [MAIN•BAND] to return to frequency indication in
the selected frequency band.
Note that in this manual, sections beginning with a micro-
phone icon (as at left), designate operation via the HM-133
microphone.