Icom IC-2820H Instruction Manual page 58

5
DV MODE OPERATION (Optional UT-123 is required)
D D Your own call sign programming
Your own call sign must be programmed for both digital voice
and low-speed data communications
.
sion)
q Push [F•
] to display the function guide.
wPush [MENU](V/MHz•SCAN)
screen.
eRotate [DIAL] to select "CALL SIGN MEMORY" then push
[MAIN•BAND].
rRotate [DIAL] to select "MY CALL SIGN MEMORY" then
push [MAIN•BAND].
tRotate [DIAL] to select the desired call sign channel
, then push [MAIN•BAND].
to M06)
yRotate [DIAL] to select the desired character, then push
[>](M/CALL•MW)
• Push [<](V/MHz•SCAN) (Left band's) to move the cursor left.
• Up to 8-character call signs can be entered.
• Push [ABC](TONE•DTMF) to select the character group from
capital letter characters.
• Push [12/](M/CALL•MW) (Right band's) to select the character
group from numbers or symbols.
• Push [CLR](DUP•MONI) to clear the selected character.
37
(including GPS transmis-
to enter MENU
(Right band's)
to move the cursor right.
(Left band's)
u Repeat step y until your own call sign is programmed.
iPush [>](M/CALL•MW)
the cursor to "/" position.
• A to Z, 0 to 9 and "/" characters are available.
• If no note is required, skip steps i and o, go to step !0 .
(M01
o Repeat step y to program the desired 4-character note.
!0 P ush [MAIN•BAND] to store the programmed call sign
.
with note)
!1 P ush [BACK](V/MHz•SCAN)
return to frequency indication.
several times to move
(Left band's)
three times to
(Right band's)
(or