Configuring The Terminal Attributes - Huawei Quidway S3000-EI Series Operation Manual

Operation Manual - Getting Started
Quidway S3000-EI Series Ethernet Switches
III . Configuring parity on the AUX (Console) port
Table 4-5 Configuring parity on the AUX (Console) port
Configure parity mode on the AUX (Console)
port
R store the default parity mode e
By default, the parity on the AUX (Console) port is none, that is, no parity bit.
IV . Configuring the stop
Table 4-6 Configuring the stop bit of AUX (Console) port
Configure the stop bit of AUX (Console) port
Restore the default stop bit of AUX (Console) port
By default, AUX (Console) port supports 1 stop bit.
V . Configuring the data bit of AUX (C
Table 4-7 Config
Configure the data bit of AUX (Console) por
Restore the default data bit of AUX (Console) port
By default, AUX (Console) port supports 8 data bits.
4.2.4 Con figuring the Terminal Attributes
The following commands can be used for configuring the terminal attributes, including
enabling/disabling terminal service, disconnection upon timeout, lockable use
interface, configuring terminal screen length and history command buffer size.
Perform the following configuration in user interface view. Perform lock command in
user view.
I. Enabling/disabling terminal service
A fter the terminal service is disabled on a user interface, you cannot log in to the switch
through the user interface. However, the user logged in through the user interface
before disabling the terminal service can continue his operation. A
Operation
bit of AUX (Console) port
Operation
uring the dat a bit of AUX (Console) port
Operation
Huawei Technologies Proprietary
4-4
Chapter 4 User Interface Configuration
parity { even | mark | none |
odd | space }
undo parity
stopbits { 1 | 1.5 | 2 }
undo stopbits
onsole) port
t data bits { 7 | 8 }
undo databits
Command
Command
Command
fter such user logs
r