Set Ndp Holdtime; Set Ndp Timer; Display And Debug Ndp - Huawei Quidway S3000-EI Series Operation Manual

Operation Manual - Integrated Management
Quidway S3000-EI Series Ethernet Switches
2.2.4 Set NDP Holdtime
The NDP holdtime
information. The adj
and will discard the packet when it expires.
Perform the following configuration in System view.
Table 2-3 Set NDP Holdtime

Set NDP Holdtime

Restore the de
N ote that NDP holdtime is supposed t
following sect
By default, NDP is hold for up to 180 seconds.
2.2.5 Set NDP Timer
The NDP information of the adjacent nodes sha
the timely updating for local information. You can use the following command to decide
how often the N
Perform the following configuration in System view.
Table 2-4 Set NDP timer

Set NDP timer

Set the NDP timer back to the default setting
N ote that NDP tim
previous section). Otherwise, NDP information tabl
By default, NDP is transmitted every 60 seconds.
2.2.6 Display and Debug NDP
After the above configuration, execute display command in any view
running of the NDP configuration, and to verify the
reset command in user view to clear the statistics of NDP module. Execute debugging
command in user view to debug the NDP module.
specifies how long the adjacent node can keep the local node
acent device knows the holdtime from the received NDP packet
Operation
fault NDP h oldtime.
ion). Otherwise, NDP information table will be unstable.
DP information will be updated.
Operation
er is supposed to be shorter tha
Huawei Technologies Proprietary
Chapter 2 HGMP V2 Configuration
ndp timer aging aging-in-secs
undo ndp timer aging
o be lo nger than the NDP timer
ll be updated frequently to guarantee
ndp timer hello seconds
undo ndp timer hello
n the NDP holdtime (descri
e will be unstable.
effect of the configuration. Execute
2-6
Command
(described in the
Command
bed in the
to display the