Display And Debug Cluster; Hgmp V2 Configuration Example - Huawei Quidway S3000-EI Series Operation Manual

Operation Manual - Integrated Management
Quidway S3000-EI Series Ethernet Switches
the user password of the member device is different from the administrator device
cannot configure the member device. The user level will be inherited from the
administrator device when you configure the member device on the administrator
device. For example, system will retain in as user view when you configure the member
device on the administrator device.
Authorization is also required when you exit the member device view on th
administrator device. After passing the authorization, the system will enter user view
automatically.
Perform the following configuration in user view.
Table 2-23 Member accessing
Member accessing
Note that, when executed on the administrator device, if the parameter member-n
specifying member number is omitted, error message prompts. Enter quit to s
switchover operation

2.4.13 Display and Debug Cluster

A fter the above configuration, execute displ
run ning of the Cluster configuration, and to verify the effect of the configuration.
T able 2-24 Display and Debug Cluster
Display cluster state and statistics
Display the information of Candidate
devices.
Display the information about member
devices.
2.5 HGM P V2 Configuration Example
I. Net work requirments
Set up a cluster of three switches and configure an administrator device to manage the
other two members. The administrator device is connected with the members via
Ethernet0/1 and Ethernet0/2 respectively. It is connected to the external network via
Operation
.\
Operation
Huawei Technologies Proprietary
2-18
Chapter 2 HGMP V2 Configuration
Command
cluster switch-to { member-num |
mac-address H-H-H | administrator }
ay comm and in any view t
Command
display cluster
display cluster
[ mac-address H-H-H | verbose ]
display cluster
[ member-num | verbose ]
, you
e
um
top
o display the
candidates
membe rs