Setting The Unit Of Data Flow That Transmitted To Radius Server - Huawei Quidway S3000-EI Series Operation Manual

Operation Manual - Security
Quidway S3000-EI Series Ethernet Switches
2.3.14 Se tting the Unit of Data Flow that Transmitted to RADIUS Server
The following command defines the unit of the data flow s
Perform the following configurations in RADIUS scheme view.
Table 2-25 Setting the unit of data flow transmitted to RADIUS server
Set the unit of data flow
transmitted to RADIUS server
Restore the unit to the default
setting
B y default, the default data unit is byte and the default data packet unit is one packet.
2.3.15 Con figuring Local RADIUS Authenti
RADIUS service, which adopts authentication/authorization/accounting servers to
m anage users, is widely used in Quidway series switches. Besides, local
authentication/authorization service is also used in these products and it is called local
RADIUS authentication server function, i.e. realize basic RADIUS function on the
switch.
Perform the following commands in system view to create/delete local RADIUS
authentication server.
Table 2-26 Creating/Deleting local RADIUS authentication server
Create local RADIUS authentication
server
Delete local RADIUS authentication
server
By default, the IP address of local RADIUS authentication server is 127.0.0.1 and the
password is Huawei.
When using local RADIUS authentic
1) The number of UDP port used for authentication is 1645 an
1646.
2) The password configured by local-ser
the RADIUS authentication/authorization packet co
authentication in RADIUS scheme view.
Operation
Operation
Huawei Technologies Proprietary
Chapter 2 AAA and RADIUS Protocol
Command
data-flow-format data { byte | giga-byte |
kilo-byte | mega-byte } packet { giga-packet |
kilo-packet | mega-packet | one-packet }
undo data-flow-format
cation Server
local-server
password
undo local-server nas-ip ip-address
ation server function, note that,
ver command must be the same as that of
2-19
Configuration
ent to RADIUS server.
Command
nas-ip ip-address
d that for accounting is
nfigured by t he command key
key