Setting Up Configuration Environment Through Telnet; Connecting A Pc To The Switch Through Telnet - Huawei Quidway S3000-EI Series Operation Manual

Operation Manual - Getting Started
Quidway S3000-EI Series Ethernet Switches
2.2 Setting up Configuration

2.2.1 Connecting a PC to the Switch through Telnet

After you have correctly configured IP address of a
Console port (using ip address comma
(that connects to a terminal) to this VLAN (using port
telnet this switch and configure it.
Step 1: Authenticate the Telnet user via the Cons
Telnet.
Note:
By default, the password is required for authentic
switch. If a user logs in via the Telnet without pa
password has not been set !".
<Quidway> system-view
[Quidway] user-interface vty 0
[Quidway-ui-vty0] set authentication password simple xxxx (xxxx is the preset
login password of Telnet user)
Step 2: To set up the configuration environment, connect the Ethernet port of the PC to
that of the switch via the LAN.
Workstation Workstation
Serv er Serv er
Figure 2-5 Setting up configuration environment through telnet
S tep 3: Run Telnet on the PC and input the IP address of the VLAN connected to the PC
port.
Ethernet Ethernet
Workstation Workstation
PC ( for configuri n g the switch PC ( for configuri n g the switch
via Telnet ) via Telnet )
Huawei Technologies Proprietary
Environment through Telnet
VLAN interface for a switch via
nd in VLAN interface view), and added the port
command in VLAN view), you can
ole port before the user logs in by
ating the Telnet user to log in the
ssword, he will see the prompt "Login
Ethernet port Ethernet port
2-3
Chapter 2 Logging in Switch