Upload Files By Means Of Tftp; Tftp Client Configuration Example - Huawei Quidway S3000-EI Series Operation Manual

Operation Manual - System Management
Quidway S3000-EI Series Ethernet Switches

1.4.4 Upload Files by means of TFTP

To upload a file, the client sends a request to the TFTP server and then transmits data
to it and receives the acknowledgement from it. You can use the following commands
to upload files.
Perform the following configuration in system view.
Table 1-17 Upload files by means of TFTP
Upload files by means of TFTP

1.4.5 TFTP Client Configuration Example

I. Networking requirement
The switch serves as TFTP client and the remote PC as TFTP server. Authorized TFTP
directory is set on the TFTP server. The IP address of a VLAN interface on the switch is
1.1.1.1, and that of the PC is 2.2.2.2. The interface on the switch connecting the PC
belong to the same VLAN.
The switch application switch.app is stored on the PC. Using TFTP, the switch can
download the switch.app from the remote TFTP server and upload the vrpcfg.txt to the
TFTP server under the switch directory for backup purpose.
II. Networking diagram
Switch Switch Switch
Figure 1-5 Networking for TFTP configuration
III. Configuration procedure
1) Start TFTP server on the PC and set authorized TFTP directory.
2) Configure the switch
# Log into the switch (locally through the Console port or remotely using Telnet).
<Quidway>
Operation
Network Network
Huawei Technologies Proprietary
1-13
Chapter 1 File System Management
Command
tftp put mmm.nnn //A.A.A.A/xxx.yyy
PC PC