Huawei Quidway S3000-EI Series Operation Manual page 304

Operation Manual - System Management
Quidway S3000-EI Series Ethernet Switches
3) Sending the configuration information to monitor terminal
Table 4-15 Sending the configuration information to monitor terminal
Device
Switch
4) Sending the configuration information to log buffer.
Table 4-16 Sending the configuration information to log buffer
Device
Switch
5) Sending the configuration information to trap buffer.
Configuration
Enable info-center
Set the information
output direction to
monitor
Set information
source
Enable the terminal
display function and
this function for the
corresponding
information
Configuration
Enable info-center
Set the information
output direction to
logbuffer
Set information
source
Huawei Technologies Proprietary
Chapter 4 System Maintenance and Debugging
Default value Configuration description
By default,
Other configurations are valid
info-center is
only if the info-center is enabled.
enabled.
- -
You can define which modules
and information to be sent out
and the time-stamp format of
information, and so on. You
-
must turn on the switch of the
corresponding module before
defining
information.
For Telnet terminal and dumb
terminal, to view the information,
you must enable the current
-
terminal display function using
the
command.
Default value Configuration description
By default,
Other configurations are valid
info-center is
only if the info-center is enabled.
enabled.
You can configure the size of the
-
log buffer at the same time.
You can define which modules
and information to be sent out
and the time-stamp format of
information, and so on. You
-
must turn on the switch of the
corresponding module before
defining
information.
4-10
output debugging
terminal monitor
output debugging