Configuration Example; Power-Feeding Supply Configuration Example - Huawei Quidway S3000-EI Series Operation Manual

Operation Manual - Remote Power-feeding
Quidway S3000-EI Series Ethernet Switches
1.3 Displaying Remote Power-Fe
After the above configuration, execute the display commands in any view to display
the running of the remote power-feeding configuration, and to verify the effect of the
configuration.
Table 1-10 Displaying remote power-f
Display the remote power-feeding status
of specified port or all ports
Display the power of specified port or all
ports
Display the PoE parameters of
power supply device
For details about the
1.4 Conf iguration Example
1.4.1 Pow er-feeding Supply Configuration Example
I. Networking requirements
Ethernet0/1 of the S3026C-PWR connects to an S2
connects to an Access Point (AP) and Ethernet0/24 is supposed to connect to an
important AP.
The S3026C-
non-802.3af-compliant PDs. Among the ports, Ethernet0/2 supply power to outside
through spare lines. The AP devices have a p
S2016C 12000
connected to Ethernet0/24 shall be powered preferentially.
Operation
parameters, refer to the relevant comman
PWR supply power to its connected devices, including those
milliwatt. Ev en if the S3026C-PWR supp
Huawei Technologies Proprietary
1-7
Chapter 1 Remote Power-Feeding Configuration
eding
eeding
display poe interface { interface-name
| interface-type interface-num | all }
display poe
{ interface-name
interface-num | all }
PSE
display poe powersupply
016C Ethernet switch, Ethernet0/2
ower consumption of 2500 milliwatt and
Command
interface power
| interface-type
d manual.
lies power t o the full, PDs