Chapter 3 Cluster Multicast Mac Address Configuration - Huawei Quidway S3000-EI Series Operation Manual

Operation Manual - Integrated Management
Quidway S3000-EI Series Ethernet Switches
Chapter 3 Cluster Multicast MAC Address
3.1 Con figuring Cluster
3.1.1 Con figuring Cluster Multic
After the establishment of the clu
which can be learnt by both member and administrative devices for cluster
a dministration. Member devices can learn the multicast information delivered by the
administrative device, implementing the delivery of multicast information from the
administrat
when NDP multicast packets, NDTP multicast packet, and HABP multicast packets are
sent within the cluster, thus avoiding the transmission problem of BPDU packets of the
STP protocol when O/E converter is used.
This configuration procedure only can be used to the administrative device.
Perform the following configuration in cluster view.
Table 3-1 Configure cluster multicast MAC address
Configure cluster multicast MAC address
Configure time interval for sending multicast packets
by the administrative device
After configuring the cluster multicast MAC address, if the time interval for sending
multicast packets by the administrative device is 0, the system prompts you to
configure the time interval.
When the time interval is set to 0, the administrative device does not send multicast
packets to the cluster member switches.
Configuration
Multicast MAC Address
ast MAC Address
ive device to the member device. The new multicast MAC address is used
Operation
Huawei Technologies Proprietary
Chapter 3 Cluster Multicast MAC Address
ster, you can configure the multicast MAC address
3-1
Configuration
Command
clustetr-mac H-H-H
cluster-mac syn-interval
time-interval