Calling Acl To Control Telnet Users; Configuration Example - Huawei Quidway S3000-EI Series Operation Manual

Operation Manual - QoS/ACL
Quidway S3000-EI Series Ethernet Switches
Table 3-1 Defining the ba
Enter
system view)
add a sub-item to the ACL(from
basic ACL view)
delete a sub-item from the
ACL(from basic ACL view)
Delete one ACL or all the
ACL(from system view)
In the defining process, you can configure several rules for an ACL, using the rule
command repeatedly.

3.2.2 Calling ACL to Control TELNET Users

T o control TELNET users with ACL, you can call the defined ACL in user-interface view.
You can use the following command to call an ACL.
Perform the f
Table 3-2 C
Enter
sy tem view) s
Call an ACL(from user-interface
view)
For detailed description of the command, refer to the Command Manual.
No te:
Only the numbered ACL can be called for TELNET user control.
3.2.3 Con figuration Example
I. Networking requirements
Only permit
sic ACL
Operation
basic ACL view(from
ollowing configuration in corresponding view.
alling ACL to control TELNET users
Operation
user-interface view(from
TELNET user from 10.110.100.52 and 10.110.100.46 access switch.
Huawei Technologies Proprietary
Chapter 3 Logon User ACL Control Configuration
Command
acl { number acl-number | name acl-name
basic } [ match-order { config | auto } ]
rule [ rule-id ] { permit | deny } [ source
sour ce-addr wildcard | any ] [ fragment ]
[ tim e-range name ]
undo rule rule-id [ source ] [ fragment ]
[ tim e-range ]
undo acl { number acl-number | name
acl- name | all }
user-interface
[ last-number ]
acl acl-number { inbound | outbound }
3-2
Command
[ type ] first-number