Displaying And Debugging Acl - Huawei Quidway S3000-EI Series Operation Manual

Operation Manual - QoS/ACL
Quidway S3000-EI Series Ethernet Switches
Table 1-9 Activ
Operation
Activate
ACL
Deactivate an
ACL
Note:
This command su
ti me(IP ACLs inc
c ombin ation item
other is deny), the

1.2.4 Displaying and Debugging ACL

After the above configuration, execute display command in all views to display the
running of the ACL configuration, and to verify the effect of the configuration. Execute
reset command in user view to clear the statistics of the ACL module.
Table 1-10 Displaying and debugging ACL
Display the status of the time range
Display the detail information abou
ACL
Display the information about the ACL
running state
Clear ACL counters
The matched inf
th e switch's CPU. The matched inform
d isplayed by display qos-global traffic-statistic command.
For syntax description, refer to the Comman
ating ACL
packet-filter { user-group { acl-number | acl-name } [ rule rule ] |
an
{ ip-group { acl-number | acl-name } [ rule rule ] | link-group
{ acl-number | acl-name } [ rule rule ] }* }
undo packet-filter { user-group { acl-number |
rule ] | { ip-group { acl-number | acl-name } [ rule
{ acl-number | acl-name } [ rule rul
pports the process to activate the Layer-2 and IP ACLs at the sam
lude basic and advanced ACLs), however the actions of the
s should be consistent. If the actions conf
y cannot be activated.
Operation
ormation of d isplay acl config command s
Huawei Technologies Proprietary
Command
e ] }* }
display time-range { all | name }
t the display acl config { all | acl-number |
acl-name }
display acl running-packet-filter all
reset acl counter { all |
acl-name }
ation of the transmitted data by switch c
d Manual.
1-9
Chapter 1 ACL Configuration
acl-name } [ rule
rule ] | link-group
lict (one is permit and the
Command
acl-number |
pecifies the ru les treated by
e
an be