Removing The Faceplate; Installing The Nxd-500I Touch Panel - AMX Modero NXD-500i Operation/Reference Manual

Installation

Removing the Faceplate

In certain circumstances, the Faceplate must be removed and replaced with a new faceplate. Because the
device is installed against a wall, the faceplate must be removed carefully to prevent the two top prongs on the
underside of the Faceplate from being broken.
To remove the faceplate:
1.
Gently lift up on the faceplate from the bottom. Do NOT pull up from the sides or the top.
2.
Let the faceplate fall forward from the top of the device and let it pivot from the bottom.
3.
Remove the faceplate from the two bottom prongs and install the new trim ring if necessary.
4.
Place the Faceplate back onto the device. Make sure to align the Microphone, Light, and PIR Motion
sensor locations on the device to their respective openings on the Faceplate assembly.

Installing the NXD-500i Touch Panel

The NXD-500i can be installed either directly into the (optional) CB-TP5i Rough-In Box or other solid surface
environment, using solid surface screws or the included locking tabs as mounting options.
The following sections describe mounting the touch panel directly into a pre-wall rough-in box, a solid
surface, drywall, or an NXA-RK5 Rack Mount Kit.
6 NXD-500i 5" Wall/Flush Mount Touch Panel with Intercom