Removing The Axt Faceplate/Bezel - AMX COLOR TOUCH PANELS WITH AUDIO (G3 FIRMWARE) Instruction Manual

4" color touch panels with audio (firmware version g3)
Table of Contents

Advertisement

B - Main unit
(with LCD)
A - Faceplate
(bezel)
FIG. 17 Foam insulation location on a solid surface mounted AXD
12. Make sure to align the Light, IR receiver, and PIR Motion sensor locations to their respective
openings on the front bezel/faceplate. Make sure the buttons are flush against the faceplate.

Removing the AXT Faceplate/Bezel

Whereas the AXD faceplate is removable by gripping the faceplate from the notches and pulling
outwards, the AXT faceplate is secured to the enclosure via four (4) #4-40 phillips-head screws
located along the rear corners of the panel (FIG. 18).
A - Faceplate
(bezel)
FIG. 18 AXT faceplate removal and screw locations
1. Flip the AXT panel over and place the LCD onto a soft cloth to prevent scratching during the
removal process.
2. Locate the four (4) phillips-head #4-20 screws on the rear of the enclosure.
3. Remove the screws by inserting a grounded Phillips screwdriver into the screw holes and turn
the screws counter-clockwise.
4" Color Touch Panels with Audio
Foam Insulation strip
4 - #4-40 solid
surface screws
B - Main AXT unit consists of
the touch panel, internal components
and enclosure
Securing screws (4) #4-20
Installation
Remove/Install the four (4)
#4-20 screws from/into the
location indicated
19

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the COLOR TOUCH PANELS WITH AUDIO (G3 FIRMWARE) and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Axd-cp4/aAxt-cp4/a

Table of Contents