Removing The Msd-1001-L From The Backbox - AMX MST-1001 Installation & Hardware Reference Manual

Removing the MSD-1001-L from the Backbox

The clips on the bottom edge of the Backbox lock down the MSD-1001-L and must be unlatched in order to remove the touch panel
from the Backbox. To do this, you ll need a thin probe such as an straightened paper clip:
1. With a straightened paper-clip, carefully press straight into the access holes indicated in FIG. 26, to disconnect the two bottom
latches.
Gently press up through these holes with a thin
probe such as a straightened paper clip to
release the panel from the tabs in the Backbox
FIG. 26 MSD-1001-L/BACKBOX ASSEMBLY
2. Grasp the bottom of the panel and gently pull outward until the bottom edge of the panel is free of the Backbox. Use your
other hand to stabilize the front of the touch panel. Always pull on the panel's plastic bezel - NEVER pull on the glass edge
(FIG. 27):
Lift the bottom edge of the panel by the plastic bezel
and gently rotate up and away from the Backbox
Note: To avoid damaging the
panel, always pull on the plastic
bezel - do not pull on the glass.
FIG. 27 MSD-1001-L/BACKBOX ASSEMBLY (RELEASING THE BOTTOM EDGE OF THE PANEL)
3. With the bottom edge of the panel free, carefully lift up and out to release the tabs on the top edge of the panel.
Modero S Series Touch Panels - Installation & Hardware Reference Manual
Insert probe through either hole to push
the tab in and away from the panel
Note: Hold the panel to prevent it from
falling once the bottom edge is free
Installing Wall-Mount (MXD) Panels
29