Installation; Overview; Installing The Trim Ring - AMX Modero NXD-500i Operation/Reference Manual

Installation

Overview

While the NXD-500i is designed to fit into pre-existing NXD-CV5 touch panel sites, the actual installation
differs from that of the NXD-CV5 is several significant ways.
The NXD-500i can be installed either directly into the (optional) CB-TP5i Rough-In Box or another solid
surface environment, using either solid surface screws or the included locking tabs for different mounting
options.
The NXD-500i is contained within a clear outer housing known as the backbox (FIG. 3). This back box is
removed when installing the device into a wall or into a Rough-In Box.
Because of the back box, the device may be installed into either a pre-wall surface using a CB-TP5i conduit/
wallbox, or into a solid surface using the included locking tabs or either solid surface or drywall screws.
Back box
FIG. 3 NXD-500i - side view
Make sure to remove the protective plastic cover from the LCD. If the cover is not
removed, the panel may not respond properly to touch points on the LCD or allow
proper screen calibration.

Installing the Trim Ring

The outer Trim Ring is secured to the Faceplate with plastic latches. The Trim Ring must first be removed to
install the touch panel, and is later re-secured when installation is complete.
To install the Trim Ring:
1.
Place the Button Trim Ring, latch side down, atop the Faceplate.
2.
Firmly press down around the Button Trim Ring until all of the latches are securely inserted into their
openings on the Faceplate, and the Button Trim Ring is securely fastened. Verify that the Button Trim
Ring is firmly inserted onto the Faceplate and that no gaps remain between this Trim Ring and the outer
surface of the Faceplate.
3.
Place the Faceplate back onto the device. Make sure to align the Microphone, Light, and PIR Motion
sensor locations on the main unit to their respective openings on the Faceplate assembly.
NXD-500i 5" Wall/Flush Mount Touch Panel with Intercom
Installation
5