Uninstalling The Mxd-2001-Pan; Removing An Mxd-2001-Pan From Its Backbox - AMX Modero X-Series G5 Instruction Manual

Uninstalling the MXD-2001-PAN

The MXD-2001-PAN is held in place to the Backbox via screws. In certain circumstances, such as firmware updates or
other maintenance that requires accessing the device's USB or Micro-USB ports, the device may need to be removed
from the Backbox.
The side covers must be removed to access the screws that secure the panel to the Backbox.

Removing an MXD-2001-PAN From Its Backbox

1.
The MXD-2001-PAN has removable side covers on the left and right (landscape) or top and bottom (portrait)
(FIG. 27):
Removal notch
FIG. 27 MXD-2001-PAN Side Covers (highlighted in blue)
2.
For each of the two side covers - insert a flat-head screwdriver (or similar tool) into the removal notches, and
carefully prey each side of the side cover free from the molding.
3.
Once the side covers have been removed, the screws securing the panel to the Backbox are accessible.
4.
Remove the screws on each side to free the panel from the Backbox.
5.
Grasp the bottom of the panel (Landscape) or right side (Portrait) and pull gently outward until the side of the panel
is free of the Backbox. Use your other hand to hold stable the front of the touch panel.
Always pull on the frame of the touch panel. NEVER pull on the glass edge.
6.
When the first side is free, repeat the process with the other.
7.
With the edge of the touch panel free, carefully lift up and out (Landscape) or to the left and out (Portrait) to remove
the touch panel from the Backbox. Be careful not to pull on the cables or connectors.
8.
To reattach the panel to its Backbox, repeat the installation procedure.
For further information, refer to the video available at www.amx.com (go to
Newsroom > Videos > Touch Panels).
MXD/T-2001-PAN and MXD/T-1901-PAN Modero X Series® G5 Panoramic Touch Panels
Removal notch
MXT/D-2001-PAN - 20.3" X Series G5 Panels
Side Covers
Removal notch
Removal notch
25