Removing The Backbox; Detaching The Msd-1001-L Backbox - AMX MST-1001 Instruction Manual

Removing the Backbox

S Series touch panels are shipped pre-installed in a plastic Backbox. This Backbox must be detached from the panel
before installation.
Also, after installation there are circumstances (such as firmware updates or other
maintenance) that will require accessing the device's Micro-USB ports. In these
cases, the panel may need to be removed from the Backbox.
Wall-mount S Series touch panels are held in place to the Backbox via latch hooks and clips on the Backbox (FIG. 21).
The clips that lock down the panel's edges must be unlatched in order to remove the touch panel from the Backbox.
Read the following instructions and be careful when removing the touch panel from
it's Backbox. Improper handling or excessive force can result in damage to the
panel's glass touch surface.

Detaching the MSD-1001-L Backbox

1.
Orient the panel so that the panel/Backbox assembly is upside-down, and the glass is facing away from you. The
bottom of the Backbox should be facing up.
2.
On the bottom of the Backbox, press down on the front corners of the plastic (on the side nearest to the glass) to flex
it enough to unhinge the panel.
The panels in this illustration are
shown upside-down. This orientation
makes it easy to press down on the
plastic Backbox to disengage the
latches that secure the bottom of the
panel to the bottom of the Backbox.
FIG. 15 S Series Backboxes
Note that at this point, the top edge of the panel is still latched into the top of the Backbox.
3.
Rotate the top of the Backbox away from the top of the panel and carefully lift it away. Be careful not to pull on the
cables or connectors.
Modero S Series G4 Touch Panels Instruction Manual
TOP
Press down with thumbs to release
Rotate Backbox back
and lift off of panel
MSD-701-L
Installing Wall-Mount (MXD) Panels
Press down with thumbs to release
Rotate Backbox back
and lift off of panel
MSD-1001-L
Press down with
thumbs to release
Rotate Backbox back
and lift off of panel
MSD-431-L
29