Step 4: Configure A Virtual Master (Using Netlinx Studio) For Usb - AMX Modero NXD-500i Operation/Reference Manual

USB
detection
icon
FIG. 20 USB Properties windows
If a yellow exclamation point appears next to the AMX USB LAN LINK device (within
the hardware devices section of the Unplug or Eject Hardware window), stop and
close the USB operation. Reconnect the USB cable to the panel and repeat the setup
procedures. Refer to the Troubleshooting section on page 129 for more detailed
information.
To remove the USB driver association from a previously connected touch panel, navigate back to the Device
Manager, right-click on the panel's USB driver (example AMX USB LAN LINK #2) and select Uninstall
from the context menu and then OK.



Step 4: Configure a Virtual Master (using NetLinx Studio) for USB

Before beginning:
1.
Verify the panel has been configured to communicate via USB within the System Settings page and that
the USB driver has been properly configured. Refer to the previous section for more information.
2.
Launch NetLinx Studio (default location is Start > Programs > AMX Control Disc > NetLinx Studio).
3.
Select Settings > Master Communication Settings, from the Main menu to open the Master
Communication Settings dialog (FIG. 21).
FIG. 21 Master Communication Settings dialog box
NXD-500i 5" Wall/Flush Mount Touch Panel with Intercom
Once the system completes the removal of the device, the Device Manager window will refresh,
and the device will no longer appear.
The next time this device is connected to the computer, it will appear as a new hardware device and
will need to be associated again with the driver (refer to Step 2: Confirm the Installation of the USB
Driver on the PC section on page 25 for more information).
Configuring Communication
27