Table of Contents
Advertisement
Wiring a 13.5V
To use the 2-pin 3.5mm captive wire connector with a 13.5V
the external source must be connected to their corresponding locations on the connector (FIG. 33).
The connector uses locking screws to insure a connection to the device, so make sure to insert and tighten the screws before
applying power.
PWR +
GND -
To the Touch Panel
NetLinx power connector wiring diagram
FIG. 33
1.
Insert the PWR and GND wires on the terminal end of the 2-pin 3.5mm captive wire cable.
Match the wiring locations of the +/- on both the power supply and the terminal connector.
2.
Tighten the clamp to secure the two wires.
Do not tighten the screws excessively; doing so may strip the threads and damage the connector.
3.
Verify the connection of the 2-pin 3.5mm captive wire to the external 13.5V
Uninstalling the MXD-2001-PAN / MXT-1901-PAN
The MXD-2001-PAN and MXD-1901-PAN are secured to the Backbox via screws. In certain circumstances, such as firmware
updates or other maintenance that requires accessing the device's USB or Micro-USB ports, the panel may need to be removed
from the Backbox.
The side covers must be removed to access the screws that secure the panel to the Backbox.
Removing the Panel From Its Backbox
1.
The MXD-2001-PAN and MXD-1901-PAN have removable side covers on the left and right (landscape) or top and bottom
(portrait) (FIG. 34).
Note that FIG. 34 shows the MXD-1901-PAN, but the illustration applies equally to the MXD-2001-PAN. Also note that FIG. 34
shows a landscape panel but the installation of a portrait panel is essentially the same, other than the vertical orientation:
Removal notch
MXD-1901-PAN Side Covers (highlighted in blue)
FIG. 34
2.
For each of the two side covers - insert a flat-head screwdriver (or similar tool) into the removal notches, and carefully prey
each side of the side cover free from the molding.
3.
Once the side covers have been removed, the screws securing the panel to the Backbox are accessible.
4.
Remove the screws on each side to free the panel from the Backbox.
5.
Grasp the bottom of the panel (Landscape) or right side (Portrait) and pull gently outward until the side of the panel is free of
the Backbox. Use your other hand to hold stable the front of the panel.
Always pull on the frame of the touch panel. NEVER pull on the glass edge.
6.
When the first side is free, repeat the process with the other.
7.
With the edge of the touch panel free, carefully lift up and out (Landscape) or to the left and out (Portrait) to remove the touch
panel from the Backbox. Be careful not to pull on the cables or connectors.
8.
To reattach the panel to its Backbox, repeat the installation procedure.
NOTE: For further information, refer to the video available at www.amx.com (go to Newsroom > Videos > Touch Panels).
Modero X® Series G5 Touch Panels - Installation & Hardware Reference Manual
Power Connection
Removal notch
-compliant power supply, the incoming PWR and GND wires from
Power Supply
Side Covers
Installing Wall-Mount (MXD) Panels
-compliant power supply and apply power.
Removal notch
Removal notch
42
- Quick Links:
- Configuration and Programming
Hide quick links:
Advertisement
Table of Contents
