Installation
10.
The microphone cable is taped to the back box. Connect the microphone cable to its connector, making
sure that the cable does not interfere with reattachment of the Faceplate.
11.
Install the two Plastite screws attaching the NXD-500i to the back box (FIG. 5).
12.
Place the Faceplate/Trim Ring assembly (A in FIG. 8) back onto the main NXD-500i unit (B in FIG. 8).
Make sure to align the Microphone, Light, and PIR Motion sensor locations to their
respective openings on the front faceplate/bezel.
13.
Reconnect the terminal Ethernet and USB to their respective locations on the Ethernet port and NetLinx
Master.
12
NXD-500i 5" Wall/Flush Mount Touch Panel with Intercom