Raf, ^Rmf - Embedded Codes; Rmf; Rsr - AMX Modero NXD-500i Operation/Reference Manual

Dynamic Image Commands (Cont.)

^RMF

^RSR

^RAF, ^RMF - Embedded Codes

The ^RAF and ^RMF commands add and modify any and all resource parameters by sending embedded codes
and data:
"'^RAF-<resource name>,<data>'"
"'^RMF-<resource name>,<data>'"
The <data> variable uses the embedded codes described in the following table:
^RAF, ^RMF - Embedded Codes
Parameter Embedded Code
protocol
user
password
host
file
path
NXD-500i 5" Wall/Flush Mount Touch Panel with Intercom
Modify an existing resource.
This command modifies any and all resource parameters by sending embedded codes
and data.
Since the embedded codes are preceded by a '%' character, any '%' character contained
in the URL must be escaped with a second '%' character (see example).
The file name field (indicated by a %F embedded code) may contain special escape
sequences as shown in the ^RAF, ^RMF - Embedded Codes section on page 119.
Syntax:
"'^RMF-<resource name>,<data>'"
Variables:
• resource name = 1 - 50 ASCII characters
• data = Refers to the embedded codes, see the ^RAF, ^RMF - Embedded Codes section
on page 119.
Example:
SEND_COMMAND Panel,"'^RMF-Sports_Image,%ALab%%5FTest/
Images%Ftest.jpg'"
Changes the resource 'Sports_Image' file name to 'test.jpg' and the path to 'Lab_Test/
Images'.
Note that the %%5F in the file path is actually encoded as %5F.
Change the refresh rate for a given resource.
Syntax:
"'^RSR-<resource name>,<refresh rate>'"
Variable:
resource name = 1 - 50 ASCII characters.
refresh rate = Measured in seconds.
Example:
SEND_COMMAND Panel,"'^RSR-Sports_Image,5'"
Sets the refresh rate to 5 seconds for the given resource ('Sports_Image').
Description
Set protocol. HTTP (0) or FTP (1).
'%P <0-1>'
Set Username for authentication.
'%U <user>'
Set Password for authentication.
'%S <password>'
Set Host Name (fully qualified DNS or IP Address).
'%H <host>'
Full path to the location of the file or program that will return the
'%F <file>'
resource. The path must be a valid HTTP URL minus the protocol
and host.
The only exception to this is the inclusion of special escape
sequences and in the case of FTP protocol, regular expressions.
Set Directory path. The path must be a valid HTTP URL minus the
'%A <path>'
protocol, host and filename.
The only exception to this is the inclusion of special escape
sequences and in the case of FTP protocol, regular expressions.
Programming
119