Programming; Overview; Button Assignments; Page Commands - AMX Modero NXD-500i Operation/Reference Manual

Programming

Overview

The NXD-500i may be programmed, using the commands in this section, to perform a wide variety of
operations using Send_Commands and variable text commands.
A device must first be defined in the NetLinx programming language with values for the Device: Port:
System
In all programming examples - Panel is used in place of these values and represents all Modero panels).
Verify that you are using the latest NetLinx Master and Modero firmware, and verify
that you are using the latest version of NetLinx Studio and TPD4.

Button Assignments

These button assignments can only be adjusted in TPD4 and not on the panels
themselves.

Page Commands

These Page Commands are used in NetLinx Programming Language and are case insensitive.
Page Commands
@APG Add the popup page to a specified popup group, if it does not already exist.
If the new popup is added to a group which has a popup displayed on the current page along with the
new pop-up, the displayed popup will be hidden and the new popup will be displayed.
Syntax:
Variable:
Example:
Adds the popup page 'Popup1' to the popup group 'Group1'.
@CPG Clear all popup pages from specified popup group.
Syntax:
Variable:
Example:
Clears all popup pages from the popup group 'Group1'.
NXD-500i 5" Wall/Flush Mount Touch Panel with Intercom
• Button Channel Range: 1 - 4000 Button push and Feedback (per address port)
• Button Variable Text range: 1 - 4000 (per address port)
• Button States Range: 1 - 256 (0 = All states, for General buttons 1 = Off state and 2 = On state).
• Level Range: 1 - 600 (Default level value 0 - 255, can be set up to 1 - 65535)
• Address port Range: 1 - 100
"'@APG-<popup page name>;<popup group name>'"
popup page name = 1 - 50 ASCII characters. Name of the popup page.
popup group name = 1 - 50 ASCII characters. Name of the popup group.
SEND_COMMAND Panel,"'@APG-Popup1;Group1'"
"'@CPG-<popup group name>'"
popup group name = 1 - 50 ASCII characters. Name of the popup group.
SEND_COMMAND Panel,"'@CPG-Group1'"
Programming
73