AMX Modero NXD-500i Operation/Reference Manual page 67

Protected Setup Page (Cont.)
Options:
System Recovery:
Reboot/Shutdown Panel: Reboot: Pressing this button causes the panel to restart after saving any changes.
FIG. 47 Protected Setup page-System Recovery confirmation dialog
NXD-500i 5" Wall/Flush Mount Touch Panel with Intercom
Allows selection of various touch panel features:
• The Function Show button enables the display of the channel port and channel
code in the top left corner of the button, the level port and level code in the bottom
left corner, and the address port and address code in the bottom right corner (see
FIG. 48 for an example of the function locations).
• Use the Page Tracking button to toggle page tracking. When enabled, the touch
panel sends page data back to the NetLinx Master, or vice versa depending on
the touch panel settings.
• Use the Telnet button to enable or disable the telnet server on the panel. This
feature focuses on direct telnet communication to the panel.
• Use the Front Button Setup Access button to activate the grey Front Setup
Access button (located below the LCD) to access the firmware pages.
- Default condition is On.
- Press and hold this grey button for 3 seconds to access the Setup page.
- Press and hold this grey button for 6 seconds to access the Calibration page.
• Use the Security button to display one of three security settings: Standard,
Secure, and DoD.
Pressing this button opens a popup window allowing changes to the Security
Profile.
Note: Refer to the Security Settings section on page 56 for important information
on using this feature.
Either resets the touch panel to factory default settings and/or wipes out all existing
touch panel pages:
• The Reset System Settings button allows a user to wipe out all current
configuration parameters on the touch panel (such as IP Addresses, Device
Number assignments, Passwords, and other presets).
- Pressing this button launches a Confirmation dialog (FIG. 47) which asks
you to confirm your selection.
- This dialog is configured with a delay timer that does not enable the YES button
for 5 seconds. This delay provides an additional amount of time for the user to
confirm their decision.
• The Remove User Pages button allows the removal of all current TPD4 touch
panel pages currently on the panel (including the pre-installed AMX Demo
pages).
- Pressing this button launches a Confirmation dialog (FIG. 47) which asks to
confirm your selection.
- This dialog is configured with a delay timer that does not enable the YES button
for 5 seconds. This delay provides an additional amount of time for the user to
confirm their decision.
Shutdown: Pressing this button causes the panel to shut down after saving any
changes.
Setup Pages and Descriptions
This dialog has a wait time of 5 seconds
before the YES option is enabled.
55