AMX Modero NXD-500i Operation/Reference Manual page 60

5" modero wall/flush mount touch panel with intercom
Hide thumbs Also See for Modero NXD-500i:
Table of Contents

Advertisement

Setup Pages and Descriptions
Setup Page
Exit:
Wired icon:
Connection Status icon: This visual display of the connection status allows the user to have a current update
Connection Status:
Display Timeout:
Inactivity Page Flip
Time:
Panel Brightness:
48
Returns to the Main touch panel page. In this case, the previous page is the default
Main page.
The icon to the left of the Connection Status Icon displays that the current connection
to the Master is Wired (image of three networked computers).
of the panel's connection status regardless of what page is currently active.
• A Lock only appears on the icon if the panel has established a connection with a
currently secured target Master (requiring a username and password).
Displays whether the panel is communicating externally, the encryption status of the
communicating Master, what connection type is being used (Ethernet or USB), and of
what System the panel is a part.
This visual display of the connection status is also reflected at the upper-right of each
firmware page. This allows the user to have a current visual update of the panel's
connection status regardless of what page is currently active.
• When a connection is established, the message displayed is either: "Connected via
Ethernet " or "Connected via USB ".
• If no connection can be established by the Modero panel, it will continue to try and
establish a connection while displaying: "Attempting via...".
• The word "Encrypted" appears only when an encrypted connection is established
with a target Master.
• The panel must be rebooted before incorporating any panel communication
changes and detecting any active Ethernet connections.
The Ethernet connection is only detected after the panel is rebooted.
Sets the length of time the panel can remain idle before activating the sleep mode.
When the device goes into sleep mode, the LCD is powered down.
• Press the UP/DN buttons to increase/decrease the time until the panel times out.
Range = 0 - 240 minutes.
• Use this button to set the timeout value to zero and disable the sleep mode.
Sets the number of minutes of inactivity before the panel automatically flips to a
pre-selected touch panel page. When the device goes into this inactivity mode, the
LCD does not power down.
• Press the UP/DN buttons to increase/decrease the time the panel can remain
inactive before it flips to the preset page. Range = 0 - 240 minutes.
• Use this button to set the timeout value to zero and disable the inactivity page flip
mode.
• The touch panel page used for the Inactivity page flip is shown within a small
Inactivity Page field.
Sets the display brightness level of the panel.
• Press the UP/DN buttons to adjust the brightness level. Range = 0 - 100.
• The on-screen bargraph can be dragged to adjust the Brightness level which is
then reflected as a corresponding numeric value within the Panel Brightness field.
• The Auto Brightness button, when selected, will cause the panel to dim as the
light level decreases, in order to reflect the brightness level of the room. If the panel
is touched, the backlight will temporarily brighten the panel more than the
previously selected level.
NXD-500i 5" Wall/Flush Mount Touch Panel with Intercom

Advertisement

Table of Contents
loading

Table of Contents