AMX Modero NXD-500i Operation/Reference Manual page 51

The G4 Web Control application is sent by the panel to the computer that is used for
communication. Once the application is installed, this popup will no longer appear.
This popup will only appear if connecting to the target panel using a different
computer.
8.
In some cases, a Connection Details dialog (FIG. 32) may appear that requests a VNC Server IP Address.



FIG. 32 Connection Details dialog
9.
If a WebControl password was set up on the G4 WebControl page, a G4 Authentication Session password
dialog box appears on the screen within the secondary browser window.
10.
Enter the Web Control session password into the Session Password field (FIG. 31).
This password was previously entered into the Web Control Password field within the G4 Web Control
page on the panel.
11.
Click OK to send the password to the panel and begin the session.
A confirmation message appears stating "Please wait, Initial screen loading.".
The secondary window then shows the same G4 page being displayed on the target G4 panel.
A small circle appears within the on-screen G4 panel page and corresponds to the location of the mouse cursor.
A left-mouse click on the computer-displayed panel page is the same as an actual touch on the target G4 panel
page.
NXD-500i 5" Wall/Flush Mount Touch Panel with Intercom
This is the IP address of the target touch panel, not the IP of the Master.
The IP address may be found in the System Settings page (for more information, please refer to the
System Settings Page section on page 57).
If this field does not appear, continue to step 9.
Configuring Communication
IP Address of touch panel
obtained from IP Settings section of
the System Connection page
39