Installation; Overview; Installing The Trim Ring; Removing The Faceplate - AMX NXD-500i Operation/Reference Manual

Installation

Overview

While the NXD-500i is designed to fit into pre-existing NXD-CV5 touch panel sites, the actual installation differs from
that of the NXD-CV5 is several significant ways.
The NXD-500i can be installed either directly into the (optional) CB-TP5i Rough-In Box or another solid surface
environment, using either solid surface screws or the included locking tabs for different mounting options.
The NXD-500i is contained within a clear outer housing known as the backbox (FIG. 3). This back box is removed when
installing the device into a wall or into a Rough-In Box.
Because of the back box, the device may be installed into either a pre-wall surface using a CB-TP5i conduit/wallbox, or
into a solid surface using the included locking tabs or either solid surface or drywall screws.
Back box
FIG. 3 NXD-500i - side view
Make sure to remove the protective plastic cover from the LCD. If the cover is not
removed, the panel may not respond properly to touch points on the LCD or allow
proper screen calibration.

Installing the Trim Ring

The outer Trim Ring is secured to the Faceplate with plastic latches. The Trim Ring must first be removed to install the
touch panel, and is later re-secured when installation is complete.
1.
Place the Button Trim Ring, latch side down, atop the Faceplate.
2.
Firmly press down around the Button Trim Ring until all of the latches are securely inserted into their openings on
the Faceplate, and the Button Trim Ring is securely fastened. Verify that the Button Trim Ring is firmly inserted
onto the Faceplate and that no gaps remain between this Trim Ring and the outer surface of the Faceplate.
3.
Place the Faceplate back onto the device. Make sure to align the Microphone, Light, and PIR Motion sensor
locations on the main unit to their respective openings on the Faceplate assembly.

Removing the Faceplate

In certain circumstances, the Faceplate must be removed and replaced with a new faceplate. Because the device is
installed against a wall, the faceplate must be removed carefully to prevent the two top prongs on the underside of the
Faceplate from being broken.
1.
Gently lift up on the faceplate from the bottom. Do NOT pull up from the sides or the top.
2.
Let the faceplate fall forward from the top of the device and let it pivot from the bottom.
3.
Remove the faceplate from the two bottom prongs and install the new trim ring if necessary.
NXD-500i 5" Modero Wall/Flush Mount Touch Panel with Intercom
Installation
5