Sip Settings Page - AMX Modero NXD-500i Operation/Reference Manual

Setup Pages and Descriptions

SIP Settings Page

The options on the SIP Settings page (FIG. 58) enable you to establish network settings for using your touch
panel as an IP phone. With a CSG SIP Communications Gateway (FG2182-01, -02, -03), you can use your
touch panel to make and receive local, long distance, and international phone calls, and have access to phone
features like call waiting, caller ID, call forwarding, call queuing, and voice mail.
Setting up your touch panel as a telephone requires that you set it up as one in the CSG SIP Communications
Gateway. Refer to the CSG SIP Communications Gateway Operation/Reference Guide for information on
setting up your touch panel to work as a telephone.
FIG. 58
SIP Settings Page
You may need to load a Duet module to enable the touch panel to receive SIP calls. The Duet module translates
between the standard interface and the device protocol. It parses the buffer for responses from the device,
sends strings to control the device, and receives commands from the UI module or telnet sessions.
Refer to the documentation supplied with the Duet Module for more details
.
A sample UI module is provided in the module package. It is not intended to cover
every possible application, but can be expanded as needed by a dealer to meet the
requirements of a particular installation.
Features on this page include:
SIP Settings Page
Back:
Wired icon:
Connection Status icon: The icon in the upper-right corner of each Setup page shows online/offline state of
Status:
Connection State:
66
Saves all changes and returns to the previous page.
The icon to the left of the Connection Status Icon displays that the current connection
to the Master is Wired (image of three networked computers).
the panel to the master.
• Bright red - disconnected
• Bright green - connected. Blinks when a blink message is received to dark green
every 5 seconds for half a second then go back to bright green.
• Bright yellow - panel missed a blink message from the master. It will remain yellow
for 3 missed blink messages and then turn red. It will return to green when a blink
message is received.
Note: A lock appears on the icon if the panel is connected to a secured NetLinx
Master.
This option enables the SIP Stack on startup. If you disable this option, the panel will
not attempt to read the rest of the configuration and will not register with a proxy
server. However, point-to-point SIP will still be enabled allowing for existing intercom
functionality.
This option displays whether you are connected to the proxy server.
NXD-500i 5" Wall/Flush Mount Touch Panel with Intercom