Concluding Steps - Fujitsu PRIMERGY BX924 S4 Upgrade And Maintenance Manual

Hard disk drives / Solid state drives
6.6.5

Concluding steps

Perform the following procedures to complete the task:
Ê Shift the drive into the connector on the mounting frame as described in
section "Installing SSD 0" on page 101
page 103.
Ê Tighten the 4 screws to the mounting frame as described in
SSD 0" on page 101
Ê Reinstall the HDD/SSD to their original mounting platforms as described in
section "Installing HDD/SSD" on page
Ê If applicable, install the mezzanine carrier as described in chapter
mezzanine cards" on page
Ê Close the server blade as described in section
page 56.
Ê Reinstall and secure the server blade in the system unit as described in
section "Installing the server blade in the system unit" on page
Ê If applicable, close the rack door as described in section
door" on page
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
120
or "Installing HDD/SSD 1" on page
134.
62.
91.
Upgrade and Maintenance Manual
or "Installing HDD/SSD 1" on
99.
"Closing the server blade" on
"Installing
103.
"Installing
57.
"Closing the rack
"Enabling
BX924 S4