Removing The Sas / Pch Backplane - Fujitsu PRIMERGY BX924 S4 Upgrade And Maintenance Manual

Ê If applicable, remove the mezzanine carrier as described in chapter
"Mezzanine cards" on page
Ê Remove the respective disk mounting kit from the mounting platform as
described in section
V
CAUTION!
Ensure that the drives are uniquely identified so that you can reinsert
them into their original locations after replacing the backplane.
Ê Remove the 4 screws from the mounting frame as described in section
"Removing SSD 0" on page 109
Ê Remove the HDD/SSD from the mounting frame as described in section
"Removing SSD 0" on page 109
6.6.3

Removing the SAS / PCH backplane

Figure 30: Removing the SAS / PCH backplane
Ê Loosen the two screws (see arrows) of the defective SAS / PCH backplane.
Ê Remove the defective SAS / PCH backplane from the mounting frame.
BX924 S4
121.
"Removing HDD/SSD" on page
or "Removing HDD/SSD 1" on page
or "Removing HDD/SSD 1" on page
Upgrade and Maintenance Manual
Hard disk drives / Solid state drives
108.
111.
111.
117