Fujitsu PRIMERGY BX924 S4 Upgrade And Maintenance Manual page 270

System board components
Ê Reinstall and secure the server blade in the system unit as described in
section "Installing the server blade in the system unit" on page
Ê If applicable, close the rack door as described in section
door" on page
Ê Update the system board BIOS and iRMC to the latest version as described
in section "Updating or recovering the system board BIOS and iRMC" on
page 73.
Ê When iSCSI boot is used via onboard CNA, the Onboard CNA OpROM has
to be enabled in the system board BIOS. If applicable, proceed as described
in section "Enabling Option ROM scan" on page
Ê If applicable, activate TPM functionality in the system BIOS under Security >
TPM (Security Chip) Setting > Security Chip. For more information, refer to the
"D3143 BIOS Setup Utility for PRIMERGY BX924 S4" reference manual.
Ê Verify and update time settings as described in section
time settings" on page
Ê Inform the customer about changed WWN and MAC addresses. For further
information, refer to section
on page 92.
Ê After replacing the system board in a server blade running Linux OS, update
the MAC address of the onboard network controller in the related NIC
definition file as described in section
a Linux environment" on page
Ê Enable boot watchdog functionality as described in section
watchdog functionality" on page
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
Ê If applicable, restore LAN teaming configurations as described in section
"After replacing the server blade" on page
Ê Please observe the notes on RAID rebuild in section
array rebuild" on page
I
If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller
(expansion card or onboard CNA). For further information, please refer
to section "Note on network settings recovery" on page
270
62.
86.
"Looking up changed MAC / WWN addresses"
89.
91.
92.
Upgrade and Maintenance Manual
80.
"Updating the NIC configuration file in
84.
95.
57.
"Closing the rack
"Verifying the system
"Enabling boot
"Enabling
"Performing a RAID
144.
BX924 S4