Configuration - Eaton Powerware 5125 User Manual

Chapter 5
®
EATON Powerware

Configuration

When the UPS is in Configuration mode, the front panel LEDs represent
the configuration options. Use the control buttons (On button,
Off button, and
Figure 23 shows the LEDs and Table 1 explains the corresponding
options.
To reconfigure the UPS default settings:
1. Press and hold the On button and the
for one beep (approximately five seconds). The UPS transfers to
Configuration mode.
The LEDs flash briefly and then display the enabled options.
2. Press the On button to scroll through the options. Each time you
press the button, the UPS beeps. The LED for the selected option
indicates the current setting; flashing represents disabled options
(see Figure 23 and Table 1).
Scrolling past the last LED returns to the first configuration option.
If you press the On button and nothing happens, the UPS is still in
Operation mode. Repeat Step 1 to enter Configuration mode, and
then perform Step 2.
3. Press the Off button ONCE to select the Voltage option or to
toggle the Site Wiring Fault Alarm on or off.
NOTE The UPS automatically exits Configuration mode after two minutes.
4. Press the button to confirm the selection and exit Configuration
mode. If you do not press the
original settings.
5125 Two-in-One UPS (2400/3000 VA) User's Guide
button) to modify the UPS configuration.
button, the UPS defaults to the
S
164201383 Rev C www.power-
button simultaneously
37
ware.com